On The Case | Tutorial

Ok ladies here you go!

You need to start with a 8.5×11 piece of card stock (either patterned or plain depending on if you want to decorate when you’re finished). Fold in half and score.
If you are using the Ultimate score board (always butting the edge against the handle section) you need to line your old up with the 5′ square fold mark and score at both lines either side. **If you are working with a scoring tool and ruler you need to measure and score at 1′ either side of your initial score line.
Move your initial fold up to the half fold A4 line and then score down the Gatefold A5 line. **From the last scoreline you made (not the initial one), using a ruler measure and score at 3′ and 4′ marks – ignore bit below which is doing the last line on the ultimate which you have just scored. Just turn and do the same for the other side making both sides of your initial scoreline identical*
Move this score line to the gatefold A4 mark and score again down the gatefold A5 line. Turn and do the same for the other side making both sides identical.
Turn your paper portrait and score down the gatefold A5 line at both sides. **Score 2 1/4 inches in from either side.
Score now at 1′ from that line and 1′ again leaving a 1/4′ margin to be trimmed off. **From the 2 1/4 inch line make two more score lines at 1′ each – leaving 1/4′ gap margin to be trimmed off.

Fold and score all of these lines to give them a sharp finish. Trim off the pieces as shown below (if you have followed my other tutorials etc this will be a breeze) 
Place double sided tape on all of the bits to be folded in and over.
Do one half of the box at a time. Fold the side reinforcements in on the sides and bring the outer side pieces up and over. Same for the front and the first section should look like below.
Do the same for the top section and you should have what resembles a little open suitcase
To make the barrier for inside cut a strip of sturdy card 10′. Score at 3′ from both edges. Place inside box and trim if necessary.
Once youre happy with the fit you can scallop the edge (i did mine with scissors as the card i used was too thick for the punch!) Fasten into the box with double sided tape.
Make sure your box closes securely – you can add your handles etc if you are wanting it to be more secure. The lid however does stay shut with just the insert keeping it in place.
Decorate as you wish and enjoy 🙂
Hope you have enjoyed this tutorial and please link back if you want to when you use it so i can see your creations
I’m off to the garden to see if the hens have laid more eggs – half a dozen a day is getting impossible to use so I’m going to go deliver some to the neighbours. Enjoy the sun xxx